Manufacturing
The manufacture of components and products is subject to stringent national and international standards relating to quality, safety and environment.
Relevant content
Haarup Maskinfabrik
/Case
Sound emission measurements of concrete mixer documents machine safety to the authorities.
FurnX noise-dampening school desks
/Case
FORCE Technology measured the impact noise of four different desk surfaces for the use of e.g. schools.
3rd Annual (Re)Calibration Workshop
/Event
The 3rd Annual (Re)Calibration workshop gathers the gas flow metering industry in Copenhagen.
How can air quality be mapped?
/News
Air pollution can cause great concern. Get help to map air quality.
Radio requirements and the EU Commission
/Article
A status on the harmonised standards under RED, EMC and LV directives.
Optimal product sounds make products better
/Article
Sounds from products must be designed and should not simply be an 'incidental waste product’.
Related facilities
Surface characterisation facility
/Facility
We have state-of-the-art equipment for surface characterisation and analysis. Our equipment covers both 3D-microscopy, electron microscopy and X-ray analysis.
Water laboratory
/Facility
Water laboratory applied for testing and type approval of water, heat, process and cooling meters. FORCE Technology's water laboratory has six test rigs for testing and type approval.
Senselab facilities
/Facility
SenseLab has facilities and expertise to carry out a broad spectrum of listening tests and sensory evaluation of hi-tech products that appeal to end-users’ hearing, vision and touch.
High-pressure calibration facility
/Facility
Visit the world's largest closed loop. The high-pressure calibration facility at FORCE Technology is unique in the world.
The Blade Test Centre (BLAEST)
/Facility
The Blade Test Centre ensures responsibility and continuity from start to end in the blade testing procedures, taking your high demand for quality to the next level.
Lindoe Component and Structure Testing A/S
/Facility
The established Lindoe Component and Structure Testing A/S focuses on full-scale testing of components and systems mechanically and in a climatic chamber.
Our services
From acoustics over monitoring to digital asset management. Our wide range of services addresses the industry's challenges and ensures technological solutions for the benefit of both industry and society.
Get an overview of our competences here.